Connections; Amplifier Controls - Goldmund TELOS 153 User Manual

4

CONNECTIONS

Connect the power cord to the back of the amplifier and plug it into the nearest wall plug.
For safety reasons, use only a 3 lugs grounded plug. To obtain the best sound from the
amplifier, avoid any multiple plug or extension cord.
Check if volume control is down to zero on the preamplifier.
Connect the digital input cable to the digital input 1 to 3. Connect the speaker cable to one
of the red and black terminals at the back of the amplifier. Each input has its own output
speaker connector.
You may notice that the ground of the input plug and the black speaker terminal are the
same polarity. The amplifier is non-inverting in phase.
5

AMPLIFIER CONTROLS

On the front plate of the Goldmund Telos 153 amplifier you will find only one POWER key.
As soon as the amplifier is connected to AC line, you can turn on the amplifier by pressing
the power key. When turned ON the channel is connected after a few seconds and the
front panel "POWER" LED lights up.
The amplifier may be powered OFF by turning off the "POWER" switch at any time. The
LED will fade very slowly, indicating discharge of the filter capacitors. The speakers will
be disconnected almost immediately.
When a digital signal is connected in one of the three digital inputs, the orange light will be
turned on indicating that the input is locked.
You might use all inputs simultaneously, each input has is own power amplifier module.
GOLDMUND TELOS 153 - Universal Power Amplifier - 8