Power Management Setup - Gigabyte GA-M68MT-S2 User Manual

2-7

Power Management Setup

CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
ACPI Suspend Type
Soft-Off by Power button
PME Event Wake Up
Modem Ring On
USB Resume from Suspend
Power-On by Alarm
x Day of Month Alarm
x Time (hh:mm:ss) Alarm
HPET Support
(Note)
HPET Mode
(Note)
Power On By Mouse
Power On By Keyboard
x KB Power ON Password
AC Back Function
ErP Support
: Move Enter: Select
F5: Previous Values
ACPI Suspend Type
Specifies the ACPI sleep state when the system enters suspend.
S1(POS) Enables the system to enter the ACPI S1 (Power on Suspend) sleep state.
In S1 sleep state, the system appears suspended and stays in a low power mode.
The system can be resumed at any time.
S3(STR) Enables the system to enter the ACPI S3 (Suspend to RAM) sleep state (default).
In S3 sleep state, the system appears to be off and consumes less power than in
the S1 state. When signaled by a wake-up device or event, the system resumes to
its working state exactly where it was left off.
Soft-Off by Power button
Configures the way to turn off the computer in MS-DOS mode using the power button.
Instant-Off Press the power button and then the system will be turned off instantly. (Default)
Delay 4 Sec. Press and hold the power button for 4 seconds to turn off the system. If the power
button is pressed for less than 4 seconds, the system will enter suspend mode.
PME Event Wake Up
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a PCI or PCIe de-
vice. Note: To use this function, you need an ATX power supply providing at least 1A on the +5VSB lead.
(Default: Enabled)
Modem Ring On
Allows the system to be awakened from an ACPI sleep state by a wake-up signal from a modem that
supports wake-up function. (Default: Enabled)
USB Resume from Suspend
Allows the system to be awakened from ACPI S3 sleep state by a wake-up signal from the installed USB
device. (Default: Enabled)
(Note) Supported on Windows 7/Vista operating system only.
BIOS Setup
Power Management Setup
[S3(STR)]
[Instant-Off]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
Everyday
0 : 0 : 0
[Enabled]
[32-bit mode]
[Disabled]
[Disabled]
Enter
[Soft-Off]
[Disabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 28 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults