Gigabyte GA-M68MT-S2 User Manual page 23

Date (mm:dd:yy)
Sets the system date.
Time (hh:mm:ss)
Sets the system time.
IDE Channel 0 Master/Slave, IDE Channel 1, 2, 3 Master
IDE HDD Auto-Detection, IDE Auto-Detection
Press <Enter> to autodetect the parameters of the IDE/SATA device on this channel.
IDE Channel 0 Master/Slave, Extended IDE Drive
Configure your IDE/SATA devices by using one of the three methods below:
Lets the BIOS automatically detect IDE/SATA devices during the POST. (Default)
• Auto
If no IDE/SATA devices are used, set this item to None so the system will skip the
• None
detection of the device during the POST for faster system startup.
Access Mode Sets the hard drive access mode. (Default: Auto)
The following fields display your hard drive specifications. If you wish to enter the parameters manually,
refer to the information on the hard drive.
Capacity Approximate capacity of the currently installed hard drive.
Cylinder Number of cylinders.
Head Number of heads.
Precomp Write precompensation cylinder.
Landing Zone Landing zone.
Sector Number of sectors.
Halt On
Allows you to determine whether the system will stop for an error during the POST.
Options are: "All Errors," "No Errors," "All, But Keyboard" (default), "All, But Diskette," "All, But Disk/Key."
Memory
These fields are read-only and are determined by the BIOS POST.
- 23 - BIOS Setup