Reset Buttons - QSC Q-SYS TSC-8-BK User Manual

Reset Buttons

There are two pin holes on the bottom of the TSC-8 bezel. There is a button in each of holes used to restart or reset the TSC-8. Refer to
Use a paperclip or similar object, insert it into the hole, and press carefully to activate the button. The pin holes are not labeled; references in this
document are as you are facing the touchscreen. The Device Restart is on the bottom left, the Factory Reset is on the bottom right.
1. Device Restart (left side) – this function is the same as rebooting a computer. The unit does not turn off the power, but the operating system is
stopped then restarted.
2. Factory Reset (right side) – this function resets all network settings, and the Brightness control to the initial settings set by the factory. The defaults
from the factory are:
◦ DHCP assigned IP Addresses
◦ Network ID – TSC8-nnnn (nnnn = last four digits of the LAN A port MAC address)
◦ Brightness control – centered
CompactFlash
The CompactFlash (Figure 12) is required for TSC-8 operation. Do not remove the CompactFlash Cover.
Device Restart
— Figure 12 —
Factory Reset
CompactFlash Cover
16
Figure 12.
Drywall