Page 1
P S - 8 R I I - P O W E R C O N D I T I O N E R / S E q u E N C E R...
Page 2
Three pairs of switched outlets on rear • condition is corrected. panel [For E versions: Furman’s SMP+ clamps at 376 Three non-delayed switched outlets VpK, (266 VAC RMS.)] • (one front, two rear) Circuit breaker •...
Page 3
“ON.” When switched to “OFF,” the voltage spikes and AC noise contaminating sequence is reversed, with Delay 3 losing power the equipment ground. Furman’s SMP+ with after approximately 1/2 second, Delay 2 after 5 LiFT takes another approach, ensuring optimal seconds, and Delay 1 after 10 seconds.
Page 4
P S - 8 R I I - P O W E R C O N D I T I O N E R / S E q u E N C E R BNC Connector for rear light (models GN-I or GN-LED) switched outlets the printed circuit board near the front left corner.
Page 5
Momentary switches, usually pushbutton types will remain, but the Furman’s clamping like the Furman RS-2, are normally open and stay voltage rating will be compromised. The unit closed only as long as the button is pressed. An...
Page 6
“START ON-OFF SEQuENCE” switch 4. Reattach the top cover. on the front panel. Doing so may activate an unintended sequence. If a Furman RS-1 is the MAINTAINED MODE controlling switch, contact Furman’s Tech Support There are three maintained modes of operation: department for the proper wiring diagrams.
Page 7
P S - 8 R I I - P O W E R C O N D I T I O N E R / S E q u E N C E R MOMENTARy MODE down one unit without affecting the others. Because it is a maintained-contact switch, the (JuMper plug Installed on JMp2).
Page 8
Purchaser to return the Product to the and GND (do not use a series resistor). If the Furman factory or to an authorized Furman repair LED does not light when the switch is in the ON location. Warranty claims should be accompanied...
Page 9
NOTE: All equipment being returned for repair must have a Return Authorization (RA) Number. To get an RA Number, please call the Furman Service Department, (707) 763-1010, Ext. 2370 or 2377, between 8 am and 5 pm u.S. Pacific Time.
Page 10
P S - 8 R I I - P O W E R C O N D I T I O N E R / S E q u E N C E R r e l at e d p r o d u c t s The PS-8R II, along with other Furman AC power accessories, can be an integral part of a complete AC power control system.
Page 11
P S - 8 R I I - P O W E R C O N D I T I O N E R / S E q u E N C E R PS-8R II SPECIFICATIONS Maximum Load: PS-8R II: 15 amps (1800 watts at 120 VAC) PS-8R IIE: 10 amps (2300 watts at 230 VAC) Operating Voltage: 90 to 140 VAC (“E”...
Page 12
P S - 8 R I I - P O W E R C O N D I T I O N E R / S E q u E N C E R Furman Sound, LLC. 1690 Corporate Circle...