Rear Panel Overview; Specifications - Fender Super-Sonic 22 Owner's Manual

L. POWER— Switches the unit ON-OFF. You can extend the life of
the amplifier tubes by keeping the STANDBY {M} switch down
for the first 60 seconds that the power is ON.
M. STANDBY — In standby, the amplifier outputs are disabled
while power is supplied only to the tube filaments, keeping
them warm. *Tip: Use STANDBY instead of switching the power
off during short breaks to extend the life of the tubes and
avoid the tube warm-up delay upon returning to play.
N. IEC POWER INPUT SOCKET— Connect to a grounded outlet
using the supplied power cord in accordance with the voltage
and frequency specified on the rear panel of your amplifier.
O. FUSE— Protects the amplifier from electrical faults. Only
replace a blown fuse with the type and rating specified on the
rear panel of your amplifier.
TYPE: PR 904
PART NUMBERS: 2160000x00* (120V, 60Hz)
2160005x00* (220V, 50Hz) ARG
*(Super-Sonic 22 amplifier exterior color code: Black "x"=0, Blonde "x"=4)
POWER REQUIREMENT: 120W
POWER AMP OUTPUT: 22W RMS @ 5% THD, 1kHz sine into 8Ω
INPUT IMPEDANCE: 1MΩ
OUTPUT IMPEDANCE: 8Ω
FUSES 100V-120V UNITS: F 2A L, 250V
220V-240V UNITS: F 1A L, 250V
FOOTSWITCH (INCLUDED): 4-button, (P/N 0078324000) Voicing / Channel / FX on-off / Reverb
SPEAKERS: One 8Ω, 12" Fender Special Design speaker by Eminence® (P/N 0079527000)
DIMENSIONS: HEIGHT: 17.5 in (44.5 cm)
WIDTH: 24 in (61.0 cm)
DEPTH: 8.5 in (21.6 cm)
WEIGHT: 40 lb (18.1 kg)
Rear Panel Rear Panel
P. MAIN SPEAKER / EXTENSION SPEAKER—
• Keep the internal speaker connected to the INTERNAL SPEAKER
jack for normal operation.
Q. FOOTSWITCH— Connect the included 4-button footswitch to
enable remote selection of: Amp Voicing, Channel, FX Loop
Bypass and Reverb. NOTE: The front panel pushbuttons are dis-
abled when the footswitch is connected.
R. SEND / RETURN— Effects loop jacks. Connect SEND to your
effects input and connect RETURN to the effects output.

Specifications

Specifications
2160001x00* (110V, 60Hz) TW
2160006x00* (230V, 50Hz) EUR
Product specifications are subject to change without notice.
fender.com
A speaker MUST be plugged into the INTERNAL SPEAKER
jack when the Super–Sonic amplifier is ON or damage may
occur. Switch the amplifier OFF, or to STANDBY while chang-
ing speaker connections.
2160003x00* (240V, 50Hz) AUS 2160004x00* (230V, 50Hz) UK
2160007x00* (100V, 50Hz) JPN 2160009x00* (220V, 60Hz) ROK
7 7