Table of Contents
Advertisement
REMOTE
CONTROL
MODEL
MBR3420/MBR3430
PROGRAMMING
BRAND CODES
Before using your new rcmotc control, it must bc programmed
to recognize the brands of equipment it will be used to
operate. If you are using a Zenith TV, Zenith VHS VCR or a
Zenith cable-TV decoder, it has already been programmed for
yOU.
Find the code that corresponds
to each brand and type of
equipment you are going to operate. Refer to Tables 1, 2
and 3.
For example, if you were programming
the remote for use
with a Zenith TV, you would look up "Zenith" in "Table
1.", and find code "101."
Write the brand codes for your equipment on the following
lines.
TV CODE:
CABLE
CODE:
1. Press MODE
rcpeatedly
to select
the desired
TV,
VCR or CABLE
operating
mode for the remote.
2. Press LEARN
for about 5 seconds
until the MODE
indicator
lights
for
the selected
TV,
VCR
or
CABLE
mode of operation.
3. Enter
the proper
brand
code number
for the equip-
ment to be controlled.
4. Press
LEARN.
All three
mode
indicators
should
light briefly, then turn off to indicate
the brand
code
has been programmed.
5. If all three
mode indicators
fail to light briefly,
an
error has occurred.
Repeat
steps 1-4 to try again.
6. Repeat
steps
1-4 to program
the remote
for the
other equipment
you are using.
NOTE: CABLE mode can be programmed
to operate a
second TV or second VCR, if desired.
When batteries are removed: It will be necessary to
rcprogram
the proper VCR and cable-TV decoder codes.
VCRCODE:
Operating Mode
Indicators
Numbered Buttons
Used to enter code number
for desired brand name
LEARN Button
SELECT
QUIT
®®®
®®®
®®®
PIP
FREEZE
_
<ZD C_
SWAP
TIMER
C223 C5E3 C3D
RECORD
STOP
PAUSE
(SE) CED C_3
REW
PLAY
F FWD
k
MBR3430 is Shown
Operating MODE Button
.'743-o
4 -- 6
Advertisement
Table of Contents
