Programming Brand Codes - Zenith Sentry 2 Operating Manual & Warranty

REMOTE CONTROL MODEL MBR3420
PROGRAMMING BRAND CODES
Before using your new remote control, it must be programmed to
recognize the brands of equipment it will be used to operate. If
you are using a Zenith TV, Zenith VHS VCR or a Zenith cable-
TV decoder, it has already been programmed for you.
Find the code that corresponds to each brand and type of
equipment you are going to operate. Refer to Tables 1, 2 and 3.
For example, if you were programming the remote for use
with a Zenith TV, you would look up "Zenith" in "Table 1.",
and find code "101."
Write the brand codes for your equipment on the following
lines.
TV CODE:
CABLE CODE:
VCRCODE:
1. Press MODE repeatedly to select the desired TV, VCR
or CABLE operating mode for the remote.
2. Press LEARN for about 5 seconds until the MODE
indicator lights for the selected TV, VCR or CABLE
mode of operation.
3. Enter the proper brand code number for the equipment
to be controlled.
4. Press LEARN. All three mode indicators should light
briefly, then turn off to indicate the brand code has
been programmed.
5. If all three mode indicators fail to light briefly, an
error has occurred. Repeat steps 1--4 to try again.
6. Repeat steps 1--4 to program the remote for the other
equipment you are using.
NOTE: CABLE mode can be programmed to operate a sec-
ond TV or second VCR, if desired.
When batteries are removed: It will be necessary to repro-
gram the proper VCR and cable-TV decoder codes.
Operating Mode
Indicators
Numbered Buttons
Used to enter code number
for desired brand name
LEARN Button
C_E3 r_--1
SELECT QUIT
@®®
®®®
@®®
_2_ _ CZD
MEMORY TIMER
RECORD STOP PAUSE
REW PLAY F FWD
.gf'T ON
0
(ZZ)
SOURCE
0
FLASHBK
CHANNEL
VOLUME
CD
MUTE
C_
CZD
SEARCH
CZD
"I_€/VCR
I
MBR3420 is Shown
Operating MODE Button
2733-O
5 -- 6