Advertisement
OCCURRENCE
POSSIBLE CAUSE
SOL UTION
Wash load too wet
after
Washer is overloaded.
Do not overload washer. See
Washing
spin.
Procedures.
Load is out of balance.
Rearrange load to allow proper spinning.
Drain hose is kinked.
Straighten
drain hose.
Water
does not enter
Washer lid is open.
Close washer lid.
The washer
will not fill with
washer
or it enters
water,
agitate or spin when the lid is open, and
slowly,
will only start to do so if the lid is closed.
Water supply is not adequate
in area.
Check another
faucet
in the house.
Wait until
water
supply and pressure increase.
Water
supply
faucets
are not completely
Fully open hot and cold faucets.
open.
Water is being used elsewhere in the house.
Water pressure must be at least 30 psi (260 kPa).
Avoid
running water
elsewhere
while washer
is
filling.
Water
level
does not
Water inlet hoses are kinked.
Straighten
hoses.
cover
load.
Washer is overloaded.
Do not overload washer.
Dry load level should not
be higher than top of agitator
vanes.
Warm or hot water is not
hot enough.
Hot water heater isset too low or isa distance
from washer.
Measure hot water temperature
at nearby faucet
with
candy
or
meat
thermometer.
Water
temperature
should
be at least 120°F (50°C).
Adjust water
heater as necessary.
Hot water is being used elsewhere in the
house.
Avoid using hot water elsewhere before or during
washer use. There may not be enough hot water
available for proper cleaning.
If problem persists,
your hot water system may be unable to support
more than 1 use at a time.
To conserve energy, the temperature
of the
See Operating
Instructions
for your washer.
hot wash is regulated.
Water
in washer
does
Drain hose is kinked or clogged.
Clean and straighten
the drain hose.
not drain or drains slowly.
Water
leaks.
Loose fill hose connection at faucet or washer.
Check and tighten hose connections.
Install rubber
sealing washers provided.
House drain pipes are clogged.
Unclog drain pipes. Contact
plumber if necessary.
Oversudsing.
Use less detergent.
incorrect
wash and rinse
Hot and cold water
hoses are connected
to
Connect hot water hose to hot water faucet and
temperatures,
wrong
supply faucets,
cold water hose to cold water faucet.
Water is entering
washer
Drain hose standpipe
is incorrect height.
Standpipe must be a minimum
of 33" (83.82 cm)
but tub does not fill.
high to prevent
siphoning.
See INSTALLATION
INSTRUCTIONS.
Water
is present
in tub
Lid lock malfunction.
Do not bypass lid lock.
Call your authorized
after
wash cycle is
servicer.
complete.
The drain and spin cycles
Lid lock malfunction.
Do not bypass lid lock.
Call your authorized
did not
occur,
servicer.
10
Advertisement
