Dryer Use; Starting Your Dryer - Whirlpool Duet GGW9250SU0 Use & Care Manual

DRYER USE
Statu_ Co,trot On
O _ensing 0 He_vy Du_
0 w_
Normai_
/
0 _l,lp \ 0 More Bulky.I _
0 cooJ OowtJ 0 Items
0 (yde Complete OLess Casuo[_
OWmWe_hidd \0 DeJicat#'_
\ oryne_s "_
0 comrol Locked L_gel
f
_._, TouchUp
_ Quick Dry
Manual Cycles
o H¢/h
0 Medium
0 LoW 0 Louder
0 Extra LoW 0 Sofler
0 On 0 AirOMy 0 Off
© © ©
_rinkle Shidd Temperature End Of CycieSi_tnal
(Mo,,,,d Cyde_ _,,M Hdd for 3 Seco,,_s _o
_ock/ UnJ_ck_o,,uoJ
J
Explosion Hazard
Keep flammabme materiams and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
flammabBe on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
Fire Hazard
No washer can compmetemy remove oil
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
Items containing foam, rubber, or pBastic must be dried
on a clothesline or by using an Air Cycme.
Failure to follow these instructions can resumt in death
or fire.
The following is a guide to starting your dryer. Please refer to
specific sections of this manual for more detailed information.
1. Clean lint screen before each load. See "Cleaning the Lint
Screen."
2. Place laundry into dryer and shut door.
3. Rotate the dial to select either an Automatic or Manual Cycle
then press the CONTROL ON button. The preset settings and
drying time for the cycle chosen will be displayed.
To use an Automatic Cycle
Point the dial to an Automatic Cycle.
Select DRYNESS LEVEL to adjust how dry you want the
load to be. The time displayed is an estimated length of
the cycle based on the Dryness Level selected. As the
cycle runs, the control senses the dryness of the load and
adjusts the time automatically for the selected Dryness
Level.
O More
O Less
©
Dryness
Level
NOTE: Time is not adjustable for Automatic Cycles. Pressing
the More Time or Less Time buttons will cause a triple beep,
indicating that the time cannot be changed.
• Press the WRINKLE SHIELD
TM
feature button if this
option is desired.
• Press the END OF CYCLE SIGNAL button to set signal
volume to desired level.
• Press (and hold) HOLD TO START button until dryer starts
(about 1 second).
Once an Automatic cycle has started, the WRINKLE
SHIELD
TM
feature and cycle signals can be adjusted. Press
the PAUSE/CANCEL key twice to stop the dryer and clear the
settings, allowing you to select another cycle and Dryness
Level.
14