Foxconn K8S755A series Manual page 31

1394 Header: F_1394 (optional)
The 1394 expansion cable can be connected to either the front (provided that
the front panel of your chassis is equipped with the appropriate interface) or the
real panel of the chassis.
Wake-up On LAN: WOL
Through the Wake-Up On LAN function, a wake event occurring from the net-
work can wake up the system. To utilize this function, please be sure to use an
ATX 12V power supply with a 5VSB line capable of delivering a current of at least
1A, and a LAN adapter which supports this function. Then connect the header to
the relevant connector on the LAN adapter, set "PCIPME Power Up Control" as
"Enabled" in the "Power Management Setup" section of the CMOS Setup. Save
and exit, then boot the operating system once to make sure this function takes
effect.
23
Chapter 2 Installation Instructions
TPA+
GND
TPB+
+12V
NC
1
WOL
2004-9-22, 17:16
1 2
TPA-
GND
TPB-
+12V
GND
9 10
F_1394
Signal for waking up
GND
+5VSB
23