Table of Contents
Advertisement
Onboard FDC Controller (Default: Enabled)
This option is used to set whether the onboard FDC controller is enabled.
Onboard Serial Port 1/2 (Default: 3F8/IRQ4 / 2F8/IRQ3)
These options are used to assign the I/O address and interrupt request
(IRQ) for the onboard serial port 1/2.
Note: Do not try to set the same values for serial port 1 and 2.
UART Mode Select (Default: Normal)
Use this option to select the UART mode. The setting value is determined by
the infrared module installed on the board.
UR2 Duplex Mode (Default: Half)
This option is available when UART 2 mode is set to either ASKIR or IRDA. This
option enables you to determine the infrared function of the onboard infrared
chip.
Onboard Parallel Port (Default: 378/IRQ7)
This option allows you to determine onboard parallel port controller I/O ad-
dress and interrupt request (IRQ).
Parallel Port Mode (Default: SPP)
Select an address and corresponding interrupt request for the onboard parallel
port.
ECP Mode Use DMA (Default: 3)
Select a DMA channel for the parallel port when using the ECP mode. This field
is only configurable if Parallel Port Mode is set to ECP.
34
34
Onboard SuperIO Device Menu
Chapter 3 BIOS Description
2004-8-31, 15:26
Advertisement
Table of Contents
