Getting Acquainted with the Calibrator
The Calibrator displays pressure and current
measurements simultaneously. See Table 2 and Figure 2
for front panel features.
The upper display shows the applied pressure or vacuum
(shown as a negative value). Press ENTER then UNITS
to select a different unit. When the power is cycled off and
on, the Calibrator retains the unit last selected.
The lower section of the display shows the current (up to
24 mA) applied to the current (mA) inputs, or the mA
output value.
To source loop voltage, press Z while pressing O ON.
Pushbutton operation is described in Table 3. Pump
features are shown in Figure 3 and described in Table 4.
Table 2. Front Panel Features
Item
Pressure Measurement
A
Pressure Module Input
B
Current Terminals
C
Pressure Sensor Input (install filter here)
D
Power Button
E
Current mA Measurement and Source
F
Feature
Pressure Calibrator with Electric Pump
Getting Acquainted with the Calibrator
1
6
5
4
3
Figure 2. Front Panel Features
2
Fgx005f.eps
5