Whirlpool WED5321SQ0 Quick Start Manual page 6

AUTOMATIC CYCLES
Automatic Cycles may be used for most loads. These cycles give tile
optimal drying in the shortest time. Drying time varies according to
the type of fabric, size of the load, and dryness setting.
Automatic Drying Cycles
All Auto Cycles are preset to NORMAL DRY, which is good for most
fabrics. At the end of the cycle, you may check the dryness of the
load.
• If the load is drier than you like, you may select the Less Dry
setting the next time you dry a similar load.
• If a load is not as dry as you like, you may complete drying using
a Timed cycle. You may select the More Dry setting the next time
you dry a similar load.
AccelerCare xu Sensor System Auto Moisture Sensing
Dryness is determined by an electronic sensor that "feels" the amount
of moisture in clothes as they pass over it. When the selected dryness
level is reached, the dryer goes into a cool down period of up to
10 minutes.
fAutomatk Preset Cycle Settings -"
Automatic Cycles Temperature
Load Type
Heavy Duty
High
Heavyweight mixed loads,
cottons, towels, jeans
Normal Medium
Corduroys, work clothes
Casual Low
Business casual clothes,
permanent press, synthetics
Delicate Extra-Low
Lingerie, blouses,
washable knit fabrics
Timed Dry
This cycle may be used to get up to 80 minutes of heated drying time.
Both time and temperature levels can be adjusted.
Quick Dry
Use this cycle for drying small loads or loads that need a short drying
time. This setting provides 24 minutes of heated tumbling with a cool
down period.
Touch Up
Use this cycle to help smooth out wrinkles from such items as clothes
packed in a suitcase or items wrinkled from being left in the dryer too
long. This setting provides about 20 minutes of heated tumbling
followed by a cool down period of up to 10 minutes.
J
W I0054090A
© 2005 Whirlpool Corporation.
All rights reserved.
fTimed Preset Cycle Settings
Timed Cycles Default Default Time
Load Type Temperature (Minutes)
Timed Dry High 40
Heavyweight, bulky
items, work clothes
Quick Dry Medium
Small loads
Medium
Touch Up
Helps to smooth out
_wrinkles
OPTIONS
Drum Light
On some models, press DRUM LIGHT anytime to turn the drum light
ON or OFF. When the dryer door is opened, the drum light turns on.
The drum light will turn off when the dryer door is closed or after the
dryer door has been open for 5 minutes.
WRINKLE SHIELD
TM
Option
The dryer continues to tumble every 5 minutes after the cycle is
complete to help keep wrinkles from setting into clean, dry fabrics.
The intermittent tumbling can continue for as long as 90 minutes or
until the dryer is stopped and the load removed.
NOTE: When the WRINKLE SHIELD
TM
setting is selected and the End of
Cycle Signal is on, a tone sounds every 5 minutes until the clothes are
removed, or the WRINKLE SHIELD
TM
setting ends.
Damp Dry Signal
The dryer will alert you when the clothes are approximately 80% dry,
helping avoid overdrying items that you prefer to hang dry.
End of Cycle Signal
The End of Cycle Signal produces an audible sound when the drying
cycle is finished. Promptly removing clothes at the end of the cycle
reduces wrinkling. Press END OF CYCLE SIGNAL until the desired
volume (Loud, Soft or Off) is selected.
24
20
J
_Troubleshooting - -_
Long Dry Times, Load Not Drying
Before you call service ... check for the following:
Is the lint screen clogged with lint?
• Clean the lint screen before each load.
Is the exhaust vent or outside exhaust hood clogged with lint?
, Lint should be cleaned out of the exhaust vent at least once
every 2 years.
Is the Auto Dry Cycle ending early?
, Do not use a dryer rack with an Auto Dry Cycle.
Are all of your Auto Dry Cycle loads consistently not as dry as
you would like?
, You may change the preset Dryness Level settings to increase
dryness for all Auto Dry Cycles. See "Changing Cycles,
Modifiers and Options" in the Use and Care Guide.
See the Use and Care Guide for complete details.
5/06
) TM
Registered Trademark/ Trademark of Whirlpool, U.S.A., Whirlpool Canada LP Licensee in Canada Printed in U.S.A.