Whirlpool RH4836XLT1 Installation instruction and use & care guidee Use & Care Manual page 6

keyhole s_ot
front
of hood
® Lift the range hood up under
cabinet and determine finaU
position. Mark on the underside
of cabinet the Uocadon of the four
keyhob mounting sbts. Set
range hood aside on a protected
surface.
drill pilot hole
® Use 1/8" (or 3 ram) ddH bit
and drill 4 pibt hobs as shown.
1/4"
(6.4 rnm)
I O. Remove the 4 hood
mounting screws from the parts bag
and install in pilot hoUes. Leave
screw' heads away from shim
strips about 1/4" (6.4 cm)
1[] if using direct wiring, make
sure power is disconnected, and pull
about 12" (30 cm) of wire through
wail or cabinet and into opening.
installations, one end of the vent
connector may need to be
trimmed to clear the electrical
strain relief.
Make electrical
Electrical Shock Hazard
Disconnect power before making
electrical connections.
Connect ground w{re to green
ground screw in terminal box.
Failure to do so can result in
death or electricaJ shock.
5® Depress both sides of the
light lens until tabs disengage
from slots in hood and remove
lens.
Install two 40 watt (maximum)
type Aq5 appliance bulbs.
Reinstall light lens. Depress both
sides of lens, insert tabs into slots
and release.
6[] For non-vented
installations: Grasp tab at front
center of filter. Push toward back
to release filter from spring clips
at front. Puil down then froward
to remove aluminum mesh filter.
Install non-vented filter
(purchased separately) by
inserting into channel at back of
compartment. Grasp tab and pull
forward so that filter snaps under
spring dips at front.
To get the most efficient
use from your new range
hood, read the "Use and
Care mnformation" section.
Keep your Whirlpool
mnstaHation instructions and
Use and Care Guide close
to range hood for easy
reference.
2[] Lift range hood into final
position, feeding electrical wire
through wiring opening. Position the
range hood so that the large end of
the keyhole slots are over the
screws.Then push the hood toward
the wail so that the screws are in the
neck of the slots.Tighten mounting
screws to cabinet, making sure
mounting screws are in narrow neck
of slots. Make sure that damper
blade, if used, rotates up and down
freely.
13m Connect ventwork to hood.
Seal joints with duct tape to make
the secure and air tight.
Note: Damper/vent connector and
round vent plate can be installed
up to 1/2" (12.7 ram) on either
side of hood center if ventwork is
off-center, in extreme off-center
green groun¢
screw
14"[] Directwiring:
Connect the white and black wires
of the power supply cable to the
white and black leads in the hood
with twist-on connectors.
Connect the power supply ground
wire to the green ground screw'
inside the terminal bex.
Use caulking to seal wire opening.
Replace terminal box cover.
Using a U.L.-listed power
supply cord-connection kit
(U.S. only}:
FoHew Power Cord }(it instructiens for
connecting wi_ng.