Whirlpool RH4836XLT1 Installation instruction and use & care guidee Use & Care Manual page 5

®Fromthe diagramsbelow,
sebct the diagramfor your
instalhtion.
Vented
installations: Cut the vent
system and electrical wiring
access hobs as required. Either
wiring hob can be used.
Non=vented installations: Cut only
the one 1=1/4" (3.2 cm) dia. wiring
access hob required, if wiring
through the top, use Iocadon
shown in VERTICAL vent systems.
if wiring through the back, use
location shown in HORIZONTAL
vent system.
Prepare and install
the hood
Excessive Weight Hazard
Use two or more people to move
and install range hood.
Failure to do so can result in
back or other injury.
Vertical rectangular vent:
Attach the damper/vent
connection with two screws as
shown.
Insert damper/vent connection
through wall
cutout and
into vent
5-1/2" 1-1/2" waH 1-1/4"
(14 sin) (3,8 cm) (3.2 era) 2"
alia, ho_e (5.1 era)
3-1/4" x 10" (8.3 x 25.4 cm)
RECTANGU LAR VERTICAL
vent system
center,ins.
8" [20,3 sin) _._ 7-1/2"
wall 5" 1-1/4"
2 _Y
(12_7 sin) (3.2 sin)
dia, ho_e (&l sm)
7" (17.8 cm)
vent system
centerHne
(1&1 sin)
3ol/4" x 10" (8.3 x 25.4 cm)
vent system
® Remove terminal box cover.
Depending on your installation,
remove either back or top wiring
knockout.
Remove the rectangular
damper/vent connector from
under the left side of hood. Set
connector and screws aside for
use if connecting to a rectangular
vent system.
For vented installations, go to
Step 7a.
For non-vented installations,
go to Step 7e.
bumps
J_ F___X /baffle
7a [] For vented installations:
Insert the baffle plate into slot
behind grille.The Iocator bumps
should be at the top as shown.
Remove either top or rear
rectangular vent knockout. If
using round vent, remove both
top rectangular and semi-circular
knockouts.
7C[] Horizontal rectangular
vent: Attach damper/vent
connection to back of hood and
insert through the wall cutout and
into the horizontal vent.
Note: if the wall cap is directly
behind the vent connector, the
dampers in the wall connector
and cap MUST NOT interfere with
each other. Remove the vent
connector damper if they interfere.
Vertical round vent:
Fasten the round adapter to the
hood with two screws as shown.
Install round damper (purchased
separately).
7e[] For non-vented
installations: Check that the baffle
plate has not been installed in
slot behind grille, if it has,
remove the baffle plate