The water dispenser will not operate properly
Check the following:
•
Is the freezer door closed completely?
•
Is the water shutoff valve not turned on, incorrectly installed or
clogged?
Is the water line connected at the source?
is there a kink in the home water source line?
Has the water system not filled? The water system needs to
be filled the first time it is used.
•
Is the refrigerator connected
to a cold water line with
water pressure of at least 30 psi? The water pressure to the
home determines the flow from the dispenser.
•
Is there a water filter installed
on the refrigerator?
The filter
may be clogged or incorrectly installed.
•
Is a reverse osmosis water filtration system connected
to
your cold water supply? See "Water Supply Requirements"
in either the Installation Instructions or the Use & Care Guide.
Water is leaking from the dispenser
Check the following:
•
Is the glass not being held under the dispenser long enough?
•
Has the water system been flushed since installation or
changing filters?
The dispenser water is not cool enough
NOTE: Water from the dispenser is only chilled to 50°F (10°C).
•
Has the refrigerator
been newly installed
or a large
amount of water recently dispensed?
Allow 24 hours for the
refrigerator to cool completely.
•
Has water
not been recently
dispensed?
The first glass of
water may not be cool. Discard the first glass of water.
WATER FILTER CERTIFICATIONS
Sla(e of California
I)epal
tn'_cnt
of Health
Sel vices
Water
Treatment
Device
Certificate
Number
04- 1635
Date Issued:
April 8, 2004
Trademark/Model
Designation
Whirlpool
T] WB2
Re_laeenlentEl_nlonts
RatedServiceCapacity:
2O0 gal_
RatodServicoFlow:
05gpm
Conditions
of Certification:
Do no_ u_e where water l_ mlc_blok)glcalIy
unsafe
ul with water _,t¸ unknown
quahty, exc_p_ that _ystem_ ccmh_d
fi_
cyst reductEo_ may be used un dEslnfectcd watcr_ that may _o_tam f_)te_aNe cyst_
10