Advertisement
3, if thereis a plastic tie in therightUpright ( 46),remove
theplastic tie,
Holdoneofthe Handrails ( 59)nearthe rightUpright ( 46)
asshown, i nserttheWireHarness (60)upthrough the
hob inthebottom ofthe Handrail andoutofthe round
hob inthesideofthe Handrail, if necessary, use
needlenose p liers to pulltheWireHarness outof the
hob, Becarefutnot to damagethe WireHarness.
Setthe Handrail (59)ontheupperendof theright
Upright ( 46),Tighten a Handrail Bolt(55)intotheright
Handrail andtheUpright a sshown,Becarefulnot to
pinchthe WireHarness(60).
Attach theotherHandrail (59)asdescribed above,Note:
Therearenowiresontheleftside,
4, SettheConsole Base(52)ontheHandrails ( 59),Thread
four3/4"Screws (2)intotheHandrails a ndtheConsole
Base, A fteryouhavestarted allfourScrews, tightenthe
Screwsuntilthey aresnug;do not overtightenthe
Screws.Note:it maybehelpful t o pressdownonthe
topof theConsole Baseabove the Handrails a syou
tighten theScrews,
insert t heWireHarness (60)through thetwoindicated
plastic tiesonthe Console Base(52)andupthrough the
hob in theConsole Baseasshown,
3
55
59
59
59
60
\
46
52
60
Ties
2
46
5, Hold the Console (65) near the Console Base (52),
Touch the right Handrail (59) to discharge
any static.
insert the Wire Harness (60) through the plastic tie
labeled C in the drawing at the right, Next, locate the
connector on the Wire Harness, Hug the Wire Harness
into the connector labeled A in the drawing at the right
and in the inset drawing, The connectors
shoutd slide
together
easily and snap into place, if they do not,
turn the connector on the Wire Harness and try again, IF
THE CONNECTOR IS NOT INSERTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Pull any slack in the Wire Harness (60) through the plas-
tic tie labeled C, and securety tighten the plastic tie
around the Wire Harness. Cut off the end of the plastic
tie,
52
59
65
_ff
Hide quick links:
Advertisement
