Advertisement
MAINTENANCE
AND TROUBLESHOOTmNG
Most treadmill
problems
can be solved by following
the simple steps below. Find the symptom
that
applies, and follow the steps listed, ff further
assistance
is needed, call toll-free
1-800-4-MY-HOME ®
(1-800-469-4663}.
PROBLEM:
The power does not turn on
SOLUTmON: a, Make sure that the power cord is plugged into a surge suppressor, and that the surge suppres-
sor is plugged into a properly grounded outlet (see page 9). Use only a single-outlet surge sup-
pressor that meets all of the specifications described on page 9. important: The treadmill is not
compatible with GFCI-equipped
outlets.
b. After the power cord has been plugged in, make sure that the key is fully inserted into the console.
Check the reseVoff circuit breaker located on the
treadmill frame near the power cord. if the switch
protrudes as shown, the circuit breaker has
tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
c
Tripped
Reset
PROBLEM:
The power turns off during
use
SOLUTION:
a. Check the reset/off circuit breaker located on the treadmill frame near the power cord (see 1. c.
above), if the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. if the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. if the treadmill still will not run, please call toll-free 1-800-4-MY-HOME _ (1-800-469-4663).
PROBLEM:
The displays
of the console do not function
propedy
SOLUTION:
a, Remove the key from the console and UNPLUG
THE POWER CORD. Next, remove the screws
from the hood and carefully remove the hood,
Locate the Reed Switch (76) and the Magnet (47)
on the left side of the Pulley (77), Turn the Pulley
until the Magnet is aligned with the Reed Switch,
Make sure that the gap between the Magnet and
the Reed Switch
is about !/8". if necessary,
loosen the Screw (3), move the Reed Switch slight-
ly, and then retighten the Screw, Re-attach the
hood, and run the treadmill for a few minutes to
check for a correct speed reading,
Top
View
3..
76_
1/8"--
j77
12
Hide quick links:
Advertisement
