Migrating The Database - Extreme Networks Ridgeline Installation Manual

Chapter 4: Upgrading the Ridgeline Software
11 Ridgeline prompts you to restart your system. You must either restart your system or start the
Ridgeline services manually before a client can connect to the Ridgeline server. Select one and then
click Finish to complete the installation process.
Figure 27: Reboot
12 Launch the License Manager and install your Ridgeline licenses. You can do this at any time after
you have installed the Ridgeline server. The server can be running while you do this, but this is not
required. See "Adding or Upgrading a License Key" on page 23

Migrating the Database

You can migrate the database as part of the standard software installation procedure (as shown in
Figure 24 on page 52) or manually, using the procedure described in this section.
NOTE
You must reconfigure multi-homed configurations manually after installation. You cannot migrate them.
The following examples describe how to perform data migration. In these procedures, EPICenter 6.0 SP5
to Ridgeline is used as examples.
For Linux and Solaris, follow the upgrade procedures in
Service Advisor to Ridgeline" on page
54
"Upgrading from EPICenter or Ridgeline
46."
for more detailed instructions.
Ridgeline Installation and Upgrade Guide