Adding/Editing The Antenna - Extreme Networks Summit WMScanner User Manual

Adding/Editing the Antenna

Clicking on the Antenna button on the Edit RFID dialog box displays the Antenna Association dialog box.
This allows you to add a new antenna, and edit, remove, move the existing antennas. This dialog box
displays the RFID information such as the model of RFID reader and the maximum number of antennas
that can be associated with the RFID reader.
Add: to add an antenna to the RFID reader click the Add button and then Click at the location in the
●
drawing, where you would like the antenna to be placed. You can also choose to place an antenna
away from the RFID reader. Continue to Click on the drawing until you are done with the antenna
placement. If you reach the maximum limit, the Summit WMScanner displays a warning message.
NOTE
To enable the add button select any empty field in any of the columns available.
Edit: this option allows you to edit the x-coordinate, y-coordinate, and antenna height. This enables
●
you to enter the absolute position of the antenna on the floor within the building. All coordinates are
given relative to the origin (also called the Floor Alignment Point) of the building coordinate system.
Summit WMScanner does not allow you to change the floor of the antenna, as the antenna can only
be placed on the same floor as that of the RFID reader.
Summit WMScanner Users Guide
157