Ap Intrusion Detection; Controller Security - Extreme Networks Summit WM3000 Series Reference Manual

Controller Security

1 Select Security from the main menu tree.
2 Refer to the following information to discern if configuration changes are warranted:
Rogue AP Intrusion
Detection
Wireless Filters
Certificates
Trustpoints
Key Pairs
The Apply and Revert buttons are greyed out within this screen, as there is no data to be configured or
saved.

AP Intrusion Detection

Use the Access Point Detection menu options to view and configure the detection of other Access Points.
310
Displays the enabled or disabled controller state to detect potentially
hostile Access Points (the definition of which is defined by you). Once
detected, rogue devices can be added to a list of devices either approved
or denied from interoperating within the controller managed network. For
more information, see "AP Intrusion Detection" on page
Displays the state of the filters used to either allow or deny a MAC
address (or groups of MAC addresses) from associating with the
controller. For more information, see
Control Lists" on page 319.
Displays the number of Server and CA certificates currently used by the
controller. For more information, see
page 411.
Displays the number of trustpoints currently in use by this controller. The
trustpoint signing the certificate can be a certificate authority, corporation
or an individual. A trustpoint represents a CA/identity pair and contains
the identity of the CA, CA-specific configuration parameters, and an
association with one enrolled identity certificate. For more information,
see "Using Trustpoints to Configure Certificates" on page
Displays the number of Key Pairs currently used by the controller. For
more information, see "Configuring Trustpoint Associated Keys" on
page 419.
310.
"Configuring Firewalls and Access
"Creating Server Certificates" on
412.
Summit WM3000 Series Controller System Reference Guide