Exmark Lazer Z Operator's Manual page 45

3/16" (4.8 mm) to
1/4" (6.4 mm)
5.2.9 Brake Adjustment.
a) Check for brake link 2.75" (7.0 cm) measurement as described in section 5.2.8.
b) Engage brake lever (lever up).
c) Measure the distance between the trunion roller and the rod collar.
Measurement should be 3/16" (4.8 mm) to 1/4" (6.4 mm). See Figure 14.
d) If adjustment is necessary, loosen the nut directly below the yoke. Turn the
bottom nut (below washer) until the correct measurement is obtained (See
Figure 14) turn nut clockwise to lengthen the gap (screws rod into yoke) and
turn counter-clockwise to shorten the gap (screws rod out of yoke). Tighten
nut against yoke and check opposite side of unit, repeat if necessary.
5.2.10 Adjust Throttle Lever Tension.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Tension in throttle lever can be adjusted by adjusting the tightness of the
lever pivot bolt, which is located under the console (See Figure 15).
5.2.11 Electric Clutch Adjustment:
No adjustment necessary.
5.2.12 Reverse Indicator Adjustment:
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Unhook seat latch and tilt seat forward.
c) Begin with either the left or right motion control lever. Move lever to the
neutral position and pull lever back until the clevis pin (on arm below pivot
shaft) contacts the end of the slot (just beginning to put pressure on
spring), See Figure 16.
d) Check where lever is relative to notch in console (should be centered
allowing lever to pivot outward to the neutral lock position).
FIGURE 14
BRAKE ADJUSTMENT
FIGURE 15
THROTTLE TENSION
- 40 -
2.75"
(7.0 cm)