Important Calls Attention To Special Removing The Mower - Toro 74625 Operator's Manual

Figure 56
Mower Decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here
1. Adjusting rod
2. Adjusting block
2
Figure 58
3. Lock nut
G014634
.
.
G009659
Figure 57
Mower Decks with 3 Blades
1. Blades front to rear 3.
2. Outside cutting edges
Measure from the tip of the
blade to the flat surface
here
Measure from the tip of the front blade to the fiat
surface and the tip of the rear blade to the fiat surface
(Figure 56 and Figure 57). If the front blade tip is
not 1/16-5/16 inch (1.6-7.9 ram) lower than the rear
blade rip, adjust the front locknut.
To adjust the front=to=rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 58).
.
.
.
To raise the front of the mower, tighten the
adjustment nut. _fb lower the front of the mower,
loosen the adjustment nut.
After adjustment, check the front-to-rear slope again.
Continue adjusting the nut until the front blade tip
is 1/16-5/16 inch (1.6-7.9 mm) lower than the rear
blade tip (Figure 56 and Figure 57).
When the front=to-rear blade slope is correct check
the side-to-side level of the mower again; refer to
Leveling the Mower from Side-to-Side.
Removing the Mower
1. Park the machine on a level surface and disengage
the blade control switch.
.
.
4.
Move the motion control levers outward to the
park position, stop the engine, remove the ke3, and
wait for all moving parts to stop before leaving the
operating position.
Lower the height-of-cut lever to the lowest position.
Remove the hairpin cotter from the front support
rod and remove the rod from the deck bracket
(Figure 59). Carefully lower the front of the mower
deck to the ground.
42