Sony KP-48S65 Operating Instructions Manual page 11

Connecting two VCRs for tape editing using MONITOR OUT
You can record input images displayed on the screen.
This type of connection should be used only when you
connect from the line input of one VCR, and from the
line output of a second VCR.
(Rear of projection "IV)
VCR (for playback)
J AUDIO VIDEO OUT_-_ I
_ m m t
R4
VIDEO 1 VIDEO 3
OUT
s VlOEO mOMTORI A UDIO
Video and audio
outputs
I
VMC-810S/820S
(not supplied)
III
0 /_ _'_ AUDIO-R(red)"-"__
-- AUDIO-L (white)
_/y VIDEO (yellow)
AU
@1
TI
x_m_ I
@1
)
F
VCR(for recording)
I AOO,o vioEo
_ Video and audio
inputs
VMC-810S/820S
(not supplied)
Notes
• Do not change the input signal while editing through
MONITOR OUT, or the output signal will also change.
• You can use the S video jack to connect a VCR for playback
and the composite video connector to connect a VCR for
recording.
• When connecting a single VCR to the projection TV, do not
connect the MONITOR OUT to the VCR's line input, while at
the same time connecting from the projection TV's VIDEO IN
connectors to the VCR's line output, as shown below.
(Rear of projection TV)
VCR
DO NOT CONNECT IN THIS WAY.
Getting Started
11-EN