Connecting
the Unit
VCR and Cable
This scenario shows a VCR with Cable signals connected through tile video
inputs. Tile Cable or VCR signals are selected by tile VCR through tile video
inputs.
To connect
the VCR and cable
1
Connect
the CATV
cable to the VCR's VHF/UHF
input jack.
2
Use an A/V and S VIDEO cables to connect
the VCR's
AUDIO and
S VIDEO
output jacks to the unit's AUDIO and S VIDEO input jacks
VIDEO
1 or 2).
._1 !f your VCR is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable,
VCR
CATV cable
S VIDEO cable
S VIDEO
VIDEO ...............
(yellow)
/
(red)
Rear of unit
S VIDEO
AN cable
o
Notes on Using This Connection
Watch the VCR or cable channels
Press V1 or V2 on the remote
control.
or
Press INPUT
on the top panel repeatedly
to select the VCR input (VIDEO
1 or 2).
Label video inputs to easily
See the instructions
for setting up Label
Video
Inputs
on page 40.
identify equipment
connected
to
the unit
19