Sharp LC-60LE920UN Service Manual page 40

LC-52LE920UN/LC-60LE920UN
11. Factory setting
After completing the factory setting, pull out the AC cord to complete the setting.
CAUTION: Do not turn on the power after completinq the factory settinq. If the power is turned on, confiqure the factory settinq aqain.
Adjustment point
1 Factory setting
Adjustment conditions
Complete the setting by
pulling out the AC cord.
Adjustment procedure
• Point the cursor to [INDUSTRY INIT], set to "ON" using [+]/[-] of the [VOL] key, and press
the [ENT] key.
The version confirmation screen appears on the green screen. It is completed when [SUC-
CESS] is displayed at the top.
(if error occurs, [ERROR] is displayed on the red screen.)
• Turn off the AC power.
The following items are initialized when configuring the factory setting.
1) User set value
2) Channel data (broadcasting frequency, etc.)
3) Password setting value
4) Operating time
5) StandbyCause
6) Auto installation flag
7) V-CHIP block setting value
12. Software version
1. Main microcomputer
2. Monitor microcomputer
3. EDID data (Analog RGB)
4. (Reference: File name in the Technical Department)
For analog RGB Input3: IC509: edid_dsub15_fullhd v6 256.BIN
13. Writing the inch and model name onto EEPROM
Writing method
1. Pull out the AC cord.
2. Copy the application for writing inch/model name (HLI2MA01 .USB) and model/inch file (52LE920.MDL) to the USB memory.
3. Hold down the power button and insert the AC cord.
4. Release the power button after 5 seconds.
5. Update starts.
LE920
UPGRADE SUCCESS
The inch and model name are displayed.
6. Pull out the AC cord.
Model/inch file
52LE920.MDL
60LE920.MDL
* 32 inch is not necessary.
NOTE: When replacing the main PWB, make sure to perform the writing the inch and model name onto EEPROM
5-14