Setting The Scsi Id Number; Setting The Terminator Switch - Epson GT-30000 Quick Start Manual

Setting the SCSI ID number

The scanner's default SCSI ID number is 2.
If you add the scanner to a system in which one of your SCSI devices already has a
SCSI ID of 2, change the ID number to an unused number using the rotary switch. See
the table below as a guide.
ID Availability
0 Not recommended
1 Not recommended
2
3
4
5
6
c
7 May not be available
Caution:
Do not set the SCSI ID to an ID number that is already assigned to another
device; otherwise the PC, scanner, and other devices will not operate
properly.

Setting the terminator switch

The scanner has a built-in terminator, which allows SCSI devices to communicate
properly with each other. You may need to change the terminator switch setting
according to your computer system.
Note:
Do not use an external terminator.
12
The SCSI ID rotary switch is located
at the rear of the scanner.
Description
Usually used for hard disk
Usually used for hard disk
Factory setting of the scanner
Usually used for the SCSI board