Table of Contents
Advertisement
Other
Information
Troubleshooting
No picture,
no sound but TV is on
Maybe the cable/air
setting is set to tile wrong position. Select GUII)I'_ [qHs+ Mel/u hon_ the Main menu, sdcct
the Setupoption,
and provide
the correct information on the following screens.
Go to pages 11_-17 for dutailed instructions.
The channel
might be empty -- change channels.
If you're watching
your VCR and it's connected
with coaxial cable to the CABLE/ANTENNA jack. tune the _ Irt() channel
3 or 4
(whichever
channel
is selected on the 3/4 sw,itch on the hack of your VCR)
Also check to make sure the TV/VCR bttltoll on the
VCR is in the correct mode (press the TV/VCR button on your VCR).
Sound okay, picture poor
Check antenna
connectkms.
Make sure all (if the cables are firmly connected
to the jacks.
TIT adjusting sharpness
function to improve _eak signals. Go to page 42 tkn"more instructions.
Black box appears on the screen
Closed-captioning might be on, Check the
Closed-Caption
DL_playcontrol panel in the ScreeJ1menu. Go to page 43 for no e
instructions.
Every time I turn
on the TV, the Guide is on the screen
The GUIDE Plus+ system automatically
appears
on the screen when you use the POWER button on the remote to turn on the TV.
You can turn off this feature by pressing GUIDE on your remote control and then select the Menu bar. Press the right arrow button
to select Setup. Choose Review oplions and select OFF
GUIDE Plus+ System
Problems
GUIDE Plus+ setup won't
switch to channel
9 for VCR and/or
channel
02 cable box
Make sure you have removed
the Demo Pin from the G-LINK iack. Check to see if the G-LINK wands are positioned
correctly
in
front of components'
remote sensors.
GUIDE Plus+ system control of cable box is slower than direct control of the box itself. Keep this in mind \'_hen changing
channels
You may have an incorrect
GUIDE Plus+ Channel Lineup. The guide may get out of sync with the cable provider. Use the GUIDE
Plus+ Setup in the GUIDEPlus+ Menu to change the zip code to 99999. Turn the TV off for 10 minutes,
Use Setup again to change
the zip code back to the correct value. If asked, be sure to select the correct channel lineup from the on-screen
list.
Program
information
doesn't
download
Review your setup information
and make sure it's correct. Press MENU on the remote and select GUIDEPlus+
Setup. Go to page 16
for detailed
instructions
about the GUIDE Plus+ Setup menus.
The TV must be off to download
information.
Leave your TV off overnight,
for at least 10 hours, to receive the initial download
for
your area.
If you're using a cable box, leave it on so you can receive program
information.
(Continued on next page)
Chapter
4
47
Advertisement
Table of Contents
