Table of Contents
Advertisement
Connections
Setup
Is a VCR connecte_l to tits TV?
• .,'Yes
_" 11111ffl
Step
3: Configuring
for a VCR
I.
If your TV is connected
to a VCR. press OK.
II it is not, highlight No and press OK (a screen appears
reminding you to
connect your (I-I.INK cahle to your TV and VCR).
2,
Irse the up and down
arrow
buttons
to highlight
the brand
Of your VCR that
is connected
to tile TV.
If your hrand isn't listed, highlight 2_bt Listed and press OK.
.
Tune your VCR to channel 02. Next, turn OFF your VCR. When you
complete these steps, press OK to begin testing.
Important
Note:
When
code testing
is in progress,
don _ttouch your
7_5
VCR, or a*_l, o/'tbe
remote
controls
for these products.
4,
Look at the front display of your VCR. If your VCR turned on automatically
and changed
to channel
09, the test was successful.
Highlight
Yes and press
OK.
If your VCR didn't change to channel
09, you can either choose No or Test
this code agafn.
If you think your TV or remotes
might have been touched
during the test,
tune your VCR to channel 02, turn off your VCR and highlight
Test this
code again.
If you don't think tl'_etest was interrupted,
highlight No. Tune your VCR to
channel 02 and turn off your VCR. Press OK (the GUIDE Plus+ system starts
testing another set of codes.)
Keep following tile previous
instructions
until the VCR finds the correct
code.
18
Chapter 1
Advertisement
Table of Contents
