FRONT PANEL INPUTS -The Shenandoah™ Stereo 60LT is equipped with two types of input jacks. The ¼” input is unbalanced and “line/instrument level” with a useable sensitivity from 50 mV to 1.6 volt. The input impedance is 220 k ohms. The ¼” input will also accept most active balanced line sources, automatically unbalancing them by recognizing the tip portion of the balanced signal.
ACTIVE EQUALIZATION - The Shenandoah™ Stereo 60LT contains a 3 band (with sweepable mid) active equalizer on both channels 1 and 2. These EQ networks, similar to those found on professional sound consoles, are very useful tools when used correctly. LOW FREQUENCY EQ - The corner frequency of the low frequency section is 125 Hz, shelving curve.
Page 4
HEADPHONE JACK -This jack, located on the rear panel, allows the user to enjoy the tone of this amp through standard headphones (8-600 ohms). A speaker switch shuts off the internal speakers. EFFECTS CANCEL JACK - A ¼” effects cancel jack is provided on the back panel to mute the internal effects via footswitch.
WARRANTY: • Genz Benz warrants the model Shenandoah™ 60LT to be free from defects in materials and workmanship for a period of 3 years from the date of purchase, when purchased from an authorized Genz Benz dealer. • This warranty does not cover normal wear and tear incurred from the normally designed use of the product. •...
SHENANDOAH™ STEREO 60LT ENGINEERING SPECIFICATIONS INPUTS XLR Balanced input impedance: 2.2 k ohms XLR Balanced input sensitivity: -60 to -30 dBV ¼” Unbalanced input impedance: 300 k ohms ¼” Unbalanced input sensitivity: -30 to +4 dBV AMPLIFIER OUTPUT Power at 4 ohm load: 30 watts per side RMS, 60 watts total THD + N (preamp): <0.035%...
Page 7
Declaration of Conformity (89/336 EEC-EMC Directive) Manufacturer’s Name: Genz Benz, a division of KMC Music Company Manufacturer’s Address: 7811 East Pierce Street Scottsdale, AZ 85287, U.S.A. Product Type: Audio Amplifier Model Number: Shenandoah™ Stereo 60LT Operating Power Condition: 100/115/230/240 V, 50/60 Hz Effective Date: 12-01-2007 Conforms to the Following Standards:...