To Remove The Oven - Whirlpool GH7145XF Use & Care Manual

REMOVING AND REPLACING THE MICROWAVE OVEN
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or
other injury.
If you need to remove your Microwave Hood Combi-
nation for any reason, follow these simple steps:
To remove:
1, Unplug microwave oven or disconnect power.
2. Remove filters and vent grille.
• If filters 0 are
installed, push in at the
tab and slide filter to the
outside edge to remove.
• Remove the two
screws O from the top
of the microwave oven
cabinet (the screws
located closest to the
front corners). Do not
remove the screws
located towards the center of the cabinet.
• Remove the vent grille _. Set the screws and
grille aside. (If grille cannot be removed, see pt. 4.)
3, After removing all oven contents, including the
e
i i I--1
turntable and support,
tape the door in the
closed position. Then
remove the two bolts
securing the
microwave oven to the
upper cabinet.
4. Hold microwave hood combination in place with
one hand. Pull hook
to release microwave
hood from mounting
plate. If grille cannot be
removed (per instructions
in pt. 2.), insert a thin
looped wire or similar tool
through an opening in
grille to pull hook.
5. Grasp the microwave oven. Rotate the microwave
__!/__ oven downward. (Be
careful that door does
not swing open.) Lift off
the support tabs _ at
__ the bottom of the mount-
ing plate. Set the micro-
wave oven aside on a
protected surface.
continued on next page