Installation Instructions; Prepare Built-In Microwave/Oven Combination; Remove Oven Door - Whirlpool WOC54EC7HW Installation Instructions Manual

Prepare Built-In Microwave/Oven
Combination
NOTES:
Refer to the following "Installation Instructions" and
■
the "Installation Instructions" section of the Installation
Instructions provided with your built-in microwave/oven
combination.
Refer and adhere to the "Electrical Requirements" section
■
and complete the instructions in the "Make Electrical
Connection" section of the Installation Instructions
provided with your built-in microwave/oven combination.
1. Decide on the final location for the oven. Avoid drilling or
cutting into house wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2. To avoid floor damage, set the oven onto cardboard prior
to installation. Do not use handle or any portion of the front
frame for lifting.
3. Remove the shipping materials and tape from the oven.
Remember to keep the corner posts and other materials
that may be needed for installation.
4. Remove the hardware package from inside the bag
containing literature.
5. Move oven and cardboard close to the oven's final location.

Remove Oven Door

IMPORTANT: Use two hands to remove oven door(s).
1. Prior to removing the oven door, prepare a surface where
you will place it. This surface should be flat and covered with
a soft blanket, or use the corner posts from your packaging
material.
2. Open the oven door.
3. Locate the oven door hinge locks in both corners of the oven
door, and rotate the hinge locks toward the oven door to the
unlocked position. If the door hinge lock is not rotated fully
(see illustration B), the door will not remove properly.
Locked
position
Grip here
to rotate.
A Oven door hinge lock
in locked position
4

INSTALLATION INSTRUCTIONS

Unlocked
position
Soft close hinge
arm on select models
B. Oven door hinge lock in
partially unlocked position
4. Partially close the door to engage the door latch locks. The
door will stop at this point.
5. Using two hands, grasp the edges of the oven door. Lift and
pull the oven door toward you and remove. You may need to
gently shift door from side to side as you pull.
6. Set the oven door(s) aside on the prepared covered work
surface, with the oven door resting on its handle.
7. To continue with the oven installation, go to the "Positioning
Oven Feet" section.