Tones; Start; Timer; Cancel - Whirlpool Velos GH7208XR Use & Care Manual

Tones are audible signals, indicating the following:
One Tone
• Valid entry (short tone)
• End of Timer countdown (long tone)
Two Tones
• Between stages (short tones)
• Reminder, repeat each minute for 15 minutes after the end-
of-cycle tones
• Hidden feature entered or exited (very short, quick tones)
Three Tones
• Invalid entry (very short, quick tones)
• Retry Error
Four Tones
• End of cycle (long tones)
• Interruption, tend to food (short tones)
• Attention - door needs to be opened and closed
To Adjust Tone Volume:
1. On Main Menu, touch "Settings & Info."
2. On Settings & Info screen, touch "More Choices."
3. Touch "Volume."
4. Using "+" and "-" controls, increase or decrease the volume
setting, or turn the tones off.
5. Touch "OK."
The new volume setting will be in effect after a brief delay.
The START control will start any function.
If non-sensor cooking is interrupted, touching the START control
pad will resume the preset cycle.
If the microwave oven has not been in use and the door has not
been opened in the past 5 minutes, the cooking function will not
start. Open and close the door, then touch START to start or
resume the cooking cycle.
For added convenience, the "Start" touch pad is also available on
some display screens, and provides the same function as the
START control pad.
The CANCEL control stops all functions except for the Timer and
Learning Mode, and cancels programming in progress.
The microwave oven will also turn off when the door is opened.
Close the door and touch START control or "Continue" on the
touch screen to resume the cycle. A sensor cooking cycle may
not be resumed if interrupted by opening the door.
During programming, the CLEAR control changes the numeric
programming values, such as minutes, seconds and cook power
that are active in the display to their default value. For example,
while entering a cook time, touching CLEAR will change the time
you have already entered to "0:00." The CLEAR control gives an
invalid signal (see "Tones" section) if touched during cooking.
The Timer can be set in minutes and seconds, up to 90 minutes,
and counts down the set time.
NOTE: The Timer does not start or stop the microwave oven.
The Timer countdown can be seen in full screen or in minimized
view. In minimized view, the countdown is always visible.
MAINMENU:
.................... 0stUsed
Jan12,2007 12:00
A. Minimized Timer countdown
While the Timer is in use, the microwave oven can still operate.
During an microwave oven operation, the Timer countdown will
be minimized. If the Timer ends while microwave oven is still
operating, the end-of-Timer tones will sound, and the set
operating mode will remain active on the screen.
To Set Timer:
1. Touch TIMER control.
2. Using the "+" and "-" controls or the number pads, enter
desired time in minutes and seconds, and then touch "Start
Timer."
The countdown will be in full screen view.
3. Touch "OK" to minimize the countdown.
To see the countdown in full screen view, touch the minimized
Timer countdown pad on the touch screen, or TIMER control.
The time can be reset during the countdown by touching TIMER,
entering a new time, then touching "OK," or the START control.
To Cancel: Touch TIMER control, then touch "Cancel Timer."
The Child Lock disables all controls to avoid unintended use of
the microwave oven. The only control that will function while the
Child Lock is active is the CANCEL pad on the control panel.
Child Lock activation is possible only when the microwave oven
is in stand-by mode.
To Activate Child Lock: Touch and hold CANCEL control for
5 seconds. Two tones will sound, and the display will show the
padlock icon.
_°MENU:
I Most Used j
Jan12,2007 12:00 Pm
13