Table of Contents
Advertisement
WASHER USE
When the Cycle Control knob is set to a number and pulled out,
the washer fills (to the selected load size) before agitation and
timing start. The washer begins agitating immediately after filling;
agitation occurs with the washer lid up or down.
During agitation, the agitator creates a continuous
rollover action
that provides a thorough cleaning of the wash load.
After agitation starts, the Cycle Control knob turns clockwise until
it points to an OFF area and the cycle ends.
NOTE: The washer pauses briefly throughout
each cycle. These
pauses are normal for washer operation.
WASH
RINSE
[_
1. Fill
_
1. Fill
2. Wash
_
2. Rinse
selected
time
_
3. Drain"
_
3. Drain
No agitation
No agitation
_
4, Spin
_
4. Spin-Spray
rinse
_
5. Spin
'The
Casual/Permanent
Press
I
_
I
6. Off
cycle partially drains,
fills, agitates briefly, and
drains.
Loading suggestions
For these suggested full-sized
loads, set the LOAD SIZE selector
to the highest setting.
SUPER CAPACITY PLUS WASHERS
Heavy Work Clothes
3 pair pants
1 coverall
3 shirts
1 overall
4 pair jeans
Delicates
3 camisoles
1 quilted robe
2 sets of sleepwear
4 slips
1 child's outfit
6 undergarments
Towels
10 bath towels
14 wash cloths
10 hand towels
1 bath mat
Mixed Load
3 double sheets
2 shirts
4 pillowcases
2 blouses
8 T-shirts
8 handkerchiefs
6 pair shorts
Your new washer may make sounds your old one didn't. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
When you select a small load size setting, your washer has a
lower water level. This can cause a clicking sound from the upper
part of the agitator.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
After drain and before spin
When the cycle changes from draining to spinning, you may hear
gears engaging.
Advertisement
Table of Contents
