Removing The Base Grille; Changing The Light Bulbs - Whirlpool ED27DQXDW01 Use And Care Manual

Removing the base grille
To remove the grille:
1. Open both doors.
2. Pull base grille forward to release the support tabs
from the metal clips.
3. Do not remove Tech Sheet fastened behind
the grille,
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place,
3. Close the doors.
See cleaning instructions for defrost pan and con-
denser coils on page 23.
Metal
clips
Condenser coils
Defrost
pan
Changing the light bulbs
Support
tabs
Base
grille
Electrical Shock Hazard
Before removing a light bulb, either unplug the
refrigerator or disconnect the electricity leading to
it at the main power supply.
Failure to do so could result in personal injury.
To change refrigerator light:
1. Disconnect refrigerator from power supply.
2. Reach behind the Control Console to remove bulb.
3. Replace bulb with a 40-watt appliance bulb,
4. Reconnect refrigerator to power supply,
To change crisper light:
1. Disconnect refrigerator from power supply.
2. Pull top of light shield forward until it snaps free.
3. Lower light shield to clear bottom supports.
4, Pull light shield straight out to remove,
5. Replace bulb with a 40-watt appliance bulb,
6, Replace light shield in reverse order.
7. Reconnect refrigerator to power supply.
Refrigerator
light
Crisper
light
20