Troubleshooting - Weed Eater FeatherLite 25 HO SST Instruction Manual

Electrolux
Hide thumbs Also See for FeatherLite 25 HO SST:
Table of Contents

Advertisement

Available languages

Available languages

• If engine does not stop, move choke to the
FULL CHOKE position.
Engine
Choke Lever
ON/STOP
HOW TO START
YOUR
UNIT
_WARNING:
The tdmmer head will
turn while starting the engine. Avoid any con-
tact with the muffler. A hot muffler can cause
serious burns.
STARTING
A COLD
ENGINE
(or a
warm
engine
after
running
out of
fuel)
ng Position
1. Set unit on a fiat surface.
2. Slowly press the pdmer bulb 6 times.
3. Move choke lever to the FULL CHOKE posi-
tion.
4. Squeeze the throttle trigger fully and hold
through all remaining steps,
Choke
"Lever
engine
still doesn't
start,
it is probably
flooded.
Proceed
to
STARTING
A
FLOODED ENGINE.
8. Once the engine starts, allow it to run 10
seconds, then move the choke lever to the
OFF CHOKE position. Allow the unit to run
for 30 more seconds at OFF CHOKE be-
fore releasing the throttle trigger.
NOTE:
If engine dies with the choke lever
in the OFF CHOKE position, move the
choke lever to the HALF CHOKE position
and pull the rope until engine runs, but no
more than 6 pulls.
STARTING
A WARM
ENGINE
1. Move the choke lever to the HALF CHOKE
position.
2. Squeeze and hold the throttle trigger. Keep
throttle trigger fully squeezed until the engine
runs smoothly.
3. Pull starter rope sharply until engine runs,
bL_no more than 5 pulls.
4. Allow engine to run 18 seconds, then move
the choke lever to OFF CHOKE.
NOTE:
if engine has not started, pull starter
rope 5 morepulls.
If engine still does not run, it
is probably flooded.
STARTING
A FLOODED
ENGINE
Flooded engines
can be started
by placing
the choke lever in the OFF CHOKE position;
then, pull the rope to clear the engine of ex-
cess fuel. This could require pulling the starter
handle many times depending on how badly
the unit is flooded.
if
the
unit
still
doesn't
start,
refer
to
TROUBLESHOOTING
TABLE
or
call
1-800-554-6723.
OPERATING
INSTRUCTIONS
OPERATING
POSITION
ALWAYS WEAR:
Eye Protection
Mumer
Primer Bulb
5. Pull starter rope handle sharply until engine
sounds as if it is trying to start, but do not pull
rope more than 6 times.
6. As soon as engine sounds as if it is trying to
star[, move choke lever to HALF CHOKE
position.
7. Pull starter rope sharply until engine tuns,
but no more than 6 pulls.
NOTE:
If the engine doesn't start after 6
pulls
(at the HALF
CHOKE
position),
move the choke lever to the FULL CHOKE
position end press the primer bulb 6 times.
Squeeze
and hold the throttle trigger and
pull the starter rope 2 more times. Move
the choke lever to the HALF CHOKE posi-
tion and pull the starter rope until the en-
gine runs, but no more than 6 pulis. If the
Heav
Cut from your right to your left.
_WARNING:
Always wear eye protec-
tion.
Never lean
over
the trimmer
head.
Rocks or debris can ricochet or be thrown into
eyes and face and cause blindness or other
serious injury.
Do not run the engine at a higher speed than
necessary. The cutting line will cut efficiently
when the engine is run at less than full throttle.
At lower speeds, there is less engine noise and
vibration. The cutting line will last longer and will
be less likely to '_Neld" onto the spool.
Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents