Maintenance - Weed Eater SST25 Instruction Manual

para}le_ tothe ground Avoid pressing the
Trimming head i nto the ground asthis can scalp the
ground and d amage the tool.
Mowing
3 inches
above ground
SCALPING - The scalping technique re-
moves unwanted vegetationdown to the
ground. Hold the bottom of the trimmer head
about 3 inches (8 cm) above the ground and
at an angle. Allow the tip ofthe line to strike the
ground around trees, posts, monuments, etc.
This technique increases line wear.
Scalping
SWEEPING - The fanning action of the rotat-
ing line can be used for a quick and easy
clean up. Keep the line para{lel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
MOWING - Your trimmer is ideaJ for mowing
ill places conventional Iawn mowers cannot
reach. In the mowing position, keep the line
III WAHI_III_ILi: Disconnect the spark
pIug before performing maintenance except
for carburetor adjustments.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Spark Pk_g Boot
• Air Filter
• Housing Screws
• Assist Handle Screws
• Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts
• STOP Switch - Ensure STOP switch func-
tions propedy by pushing and holding the
switch in the STOP position. Make sure en-
gine stops. Restart engine and continue
• Pue} Tank - Discontinue use of unit if fue_
tank shows signs of damage or leaks
• Debris Shietd - Discontinue use of unit if
debris shield is damaged
INSPECT AND CLEAN UNIT AND
LABELS
• After each use, inspect complete unit for
loose or damaged parts. Clean the un_ and
labels using a damp cloth with a mi_d deter-
gent.
• Wipe off unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consul_ption and
harmful emissions. Always clean after every
5 hours of operation.
1. CIean the air filter cover and the area
around it to keep dirt from falling into the
carburetor chamber when the cover is
opened.
2 Open air filter cover by pushing button
(see ilIustraben). Remove air filter.
NOTE: To avoid creating a fire hazard or
producing harmful evaporative emissions, do
not clean fi{ter in gasoline or other flammable
solvent.
3 Wash the filter in soap and water.
g. AlIow fiIter to dry.
5. Replace air filter and close cover.
7