Replace Spark Plug; Replace Fuel Filter; Seasonal Storage; Fuel System - Weed Eater GHT 180 LE Instruction Manual

Hide thumbs Also See for GHT 180 LE:
Table of Contents

Advertisement

Available languages

Available languages

=:_WARNINL_:
Recheck the idle speed
after each adjustment.
The blade must not
move at idle speed to avoid serious injury to
the operator or others.
Idle Speed Screw
If you require further assistance or are unsure
about performingthis procedure, contact an
authorized
service
dea_er
or
call
1-800-554-6723.
REPLACE
SPARK PLUG
Replace spark plug each year to ensure the
engine starts easier and runs better. Set
spark plug gap at 0.025 inch. Ignition timing is
fixed, nonadjustable.
1. Twist, then pul_off spark plug boot.
2. Remove spark I_ug from cylinder and dis-
card.
3. Replace with Champion RCJ-6Y spark
plug and tighten securely with a 3/4 inch
socket wrench.
4. Reinstall the spark plug boot.
REPLACE
FUEL FILTER
Toreplace fuel filter, drain unit by running itdry
of fuel, then remove fuel cap/retainer assem-
bly from tank. Pull filter from tank and remove
it from the fuel line. Install new fuel filter on fuel
_ine;reinstatl parts.
Fuel Filter
I Line
aWARNIN_:
Perform the following
steps after each use:
• Allow engine to cool, and secure the unit
before storing or transporting.
• Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.
• Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentelly cause injury.
• Store unit and fuel well out of the reach of
children.
SEASONAL
STORAGE
Prepare unit for storage at end of season or if
it will not be used for 30 days or more.
If your unit is to be stored for a period of time:
• Clean the entire unit.
• Store in a clean dry area.
• Clean all parts and check for damage.
Have damaged parts repaired or replaced
by an authorized service dealer.
• Keep all nuts, bolts, and screws tight.
• Lightly oil external metal surfaces, includ-
ing the blade.
To oil the blade, do the following:
• Stop the engine and allow blade to come to
a complete stop.
• Ensure ON/OFF switch is in the OFF posi-
tion.
• Disconnect the spark plug wtte.
• Apply a light machine oil along the edge of
the top strap as shown.
OIL
Top Strap
'\
FUEL SYSTEM
Under FUELING ENGINE in the OPERA*
TION section of this manual,see message la-
beled IMPORTANT regarding the use of ga-
sohol in your engine. Fuel stabilizer is an ac_
ceptabie alternative in minimizing the formation
of fuel gum deposits during storage. Add stabi*
iizer to gasoline in fuel tank or fuel storage con-
tainer.Follow the mix instructions foundon sta-
bilizer container. Run engine at least 5 minutes
after adding stabilizer.
-7-

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ght 220 le

Table of Contents