Weed Eater XT700 Instruction Manual page 7

para}le_ tothe ground Avoid pressing the
Trimming head i nto the ground asthis can scalp the
ground and d amage the tool.
Mowing
3 inches
above ground
SCALPING - The scalping technique re-
moves unwanted vegetation. H o_d the bottom
of the trimmer head about 3 inches (8 cm)
above the ground and at an angle. Allow the
tip of the line to stdk e the ground around trees,
posts, monuments, etc. This technique in-
creases line wear
Scalping
SWEEPING - The fanning action of the rotat-
ing line can be used for a quick and easy
clean up. Keep the line parallet to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
MOWING - Your trimmer is ideal for mowing
ill places conventional lawn mowers cannot
reach. In the mowing position, keep the line
z}, ...__.....A
ADIWAHNINLi: Disconnect the spark
plug before performing maintenance except
for carburetor adjustments.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
• Assist Handle Screw
• Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement of damaged or worn parts
• STOP Switch - Ensure STOP switch func-
tions propedy by pushing and holding the
switch in the STOP position Make sure en-
gine stops. Restart engine and continue
• FueI Tank - Discontinue use of unit if fuel
tank shows signs of damage or leaks
• Debris Shield - Discontinue use of unit if
debris shield is damaged
INSPECT AND CLEAN UNIT AND DE-
CALS
• After each use, inspect complete unit for
loose or damaged parts. Clean the unit and
decals using a damp cloth with a miId deter-
gent.
• Wipe oft unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consuf_ption and
harmful emissions. Always clean after every
5 hours of operation.
1. CIean the air filter cover and the area
around it to keep dirt from falI{ng into the
carburetor chamber when the cover is
opened.
2. Open air filter cover by pushing button
(see ilIustration). Remove air fi_ter.
NOTE: To avoid creating a fire hazard or
producing harmful evaporative emissions, do
not clean fi{ter in gasoline or other flammable
solvent.
3. Wash the filter in soap and water.
4-. Allow fi{ter to dry.
5. Replace air filter and close cover.
7