Table of Contents
Advertisement
ShiftLeverCable
Periodic adjustment of the three-speed shift cable may
be necessary due to normal wear on the cable.
Adjustment is needed if all three speeds do not work.
The adjustable cable bracket is located on the left side
of the mower beside the engine. See Figure 14.
Adjustable Cable
Bracket _
Hex Nut
"-.
•
Start engine and place shift lever in the third speed
position. Refer to Figure 13.
•
Stop engine and disconnect spark plug wire and
ground it against engine.
•
Loosen hex nut which secures the adjustable cable
bracket. See Figure 14.
•
Push back on the adjustable cable bracket and
tighten hex nut.
EngineAdjustments
Refer to the engine manual for these adjustments.
PUSH
Figure 14
SECTION 7: MAINTAINING YOUR LAWNMOWER
WARNING:
Always stop the engine and
disconnect the spark plug wire before
performing any maintenance work or
adjustments on your lawn mower.
Cleaning Mower
The underside of the mower deck should be cleaned
after each use to prevent any build-up of debris. If
allowed to accumulate, it will cause rust and corrosion.
NOTE: We do not recommend
the use of pressure
washers or garden hose to clean your unit. These may
cause
damage
to
electric
components,
spindles,
pulleys, bearings, or the engine. The use of water will
result in shortened life and reduce serviceability.
•
Disconnect spark plug wire.
•
Drain the gasoline from the lawn mower, or place a
piece of plastic under the gas cap.
•
Tip the mower so that it rests on the housing. Keep
the side with the air cleaner facing up. Hold the
mower firmly.
•
Scrape and clean the underside of the deck with a
suitable toot. Do notspray with water.
•
Put the mower back on its wheels on the ground. If
you had put plastic under the gas cap, make sure to
remove it now.
WARNING:
Never tip the mower more than
90 degrees in any directions and do not leave
the mower tipped for any length of time. Oil can
drain into the upper part of the engine causing
a starting problem.
EngineCare
A list of key maintenance jobs required for good
performance by the mower is given below. Follow the
accompanying engine manual for detailed list and
instructions.
•
Change engine oil regularly, as instructed in the
engine manual. Check oil level before starting
engine every time.
•
Service foam filter in the air cleaner every 25 hours
of use and replace the paper filter component every
100 hours. You may have to service the air filter
more frequently if you are operating the mower
under extremely dusty conditions.
•
Clean the engine periodically. Remove dirt and
debris with a cloth or brush.
•
Clean the spark plug and reset the gap to .030" at
least once a season. Refer to the engine manual for
correct spark plug type.
•
Inspect muffler periodically, and replace if
necessary. Damaged mufflers or spark arresters
can create a fire hazard. Make sure to avoid muffler
and surrounding areas while the mower engine is
hot because temperature of these areas of the
engine may exceed 150° F.
Lubrication
BladeControlHandle
•
Lubricate the pivot points on the blade control
handle at least once a season with light oil. The
blade control must operate freely in both directions.
13
Advertisement
Table of Contents
