Starting & Stopping Wheel Drive - Snapper LT200H42IBV2 series 1 Operator's Manual

Section 2 -OPERATING INSTRUCTIONS
2.3
STARTING & OPERATION (Continued)
2.3.2. STARTING WHEEL DRIVE
1. Shift speed control lever to neutral.
2. Start engine. Refer to Section "STARTING
ENGINE".
3. Release clutch/brake pedal.
4. Slowly shift speed control lever forward for
forward motion or to the rear for reverse motion. See
Figure 2.7.
SPEED COt FROL LEVER
.... REVERSE
FORWARD
i
SPEEDS
FIGURE 2.7
2.3.3 STARTING MOWER BLADE
1. Start engine. Refer to Section "STARTING
ENGINE".
2. Pull blade switch OUT to engage blade. See
Figure 2.8.
PUSH BLADE SWITCH IN TO
THE"OFF"POSITION
PULL BLADE
SWITCH OUT TO
THE "ON"
POSITION
FIGURE 2.8
WARNING L
DO NOT operate blades with machine in reverse.
STOP BLADES. LOOK and SEE behind and down
for children,pets and hazards before and while
backing.
2.4 STOPPING ENGINE, BLADE, WHEEL DRIVE
2.4.1. STOPPING ENGINE
1. Stop engine by turning key to the "OFF"
position. See Figure 2.9.
!
FIGURE 2.9
2.4.2. STOPPING WHEEL DRIVE
1. Fully depress clutch/brake pedal to stop wheel
drive. See Figure 2.10.
I
FULLY DEPRESS
i
CLUTCH/BRAKE PEDAL TO
STOP WHEEL MOTION
2
FIGURE 2.10