Important Safety Instructions - Singer 93234 Instruction Manual

IMPORTANT SAFETYINSTRUCTIONS
When using this machine, basic safety precautions should always be followed
including the following:
Read all instructions before using this machine.
DANGER.
To reduce the risk of electric shock:
• The machine should never be left unattended when plugged in. Always unplug
the machine from the electric outlet immediately after using and before cleaning.
• Always unplug before changing light bulb. Replace bulb with the same type
rated 15 wattS. Be sure to replace the face plate which covers the light blub
before operating the machine.
WARNING.
To reduce the risk of burns, fire, electric shock or injury to persons:
• Be sure that the electrical voltage of the socket outlet (wall receptacle) is
the same as the rated voltage of the motor.
• Use this machine only for its intended use as described in this Operator's
Guioe. Use only attachments recommended by the manufacturer as
conl.ained in the Operator's Guide.
• To disconnect, turn all controls to the off ("0") position, then remove plug
from outlet.
• Disconnect the power-line plug from the socket outlet or switch the machine
off when making any adjustments in the needle area, such as threading
needle, changing needle, changing needle plate or changing presser foot, etc.
• Always unplug the machine from the electrical outlet when removing
covers, lubricating, or when making any other user servicing adjustments
mentioned in the Operator's Guide.
• Do not attempt to adjust the motor belt. Contact your nearest Service Center
should any adjustment be required.
• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
• Handle the foot controller with care and avoid dropping it on the floor.
Be sure not to place anything on top of it.
• Always use the proper needle plate. The wrong plate can cause the needle
to break.
• Do not use bent needles.
• When sewing, keep fingers away from all moving parts. Special care is
required around the sewing machine needle.
• Do not pull or push fabric while stitching. This may deflect the needle causing
it to break.
• Before removing the bobbin case, remove plug from the socket outlet.
2