ELECTRICAL
ADJ USTM ENTS
2-6: FLICKER
WARNING!
If you perform this adjustment
with a metallic tool, you will
destroy the DIGITAL PCB plus the LCD panel.
To prevent this disastrous
damage, you must use a non-
metallic tool to perform the Flicker adjustment.
NOTE: The following
adjustment
is necessary
for changing
the DIGITAL PCB and Panel module.
1. Activate the adjustment
mode display of Fig. 1-2 and
press the CH. UP/DOWN button to select
"38 Flicker Pattern". (Refer to Fig. 2-1)
2. Check if the screen is flashing.
3. Turn Variable Resistor,
and adjust it not appear
FLICKER (FLASHING).
(Refer to Fig. 2-2)
Fig. 2-1
Variable
Resistor
Fig. 2-2
D-4