Picture Quality - Samsung UN32F5500 E-Manual

Picture Quality
Screen Menu > Picture
PDP 5500, LED6400 series and above
Choose a Picture Mode and then select the following options to display a slide bar that allows the
corresponding setting to be adjusted. Adjust the value by dragging left/right on the touchpad and
change the setting by dragging up/down on the touchpad. Adjusted values are applied to the current
source and will remain in effect the next time the source is selected. When connected to a computer
via an HDMI-to-DVl cable, only the Color and Tint (G/R) adjustment options can be chosen.
LED 5500 and 6300 series
Choose a Picture Mode and then select the following options to display a slide bar that allows the
corresponding setting to be adjusted. Adjust the value by pressing the left/right arrow button on the
remote and change the setting by pressing up/down arrow button on the remote. Adjusted values
are applied to the current source and will remain in effect the next time the source is selected. When
connected to a computer via an HDMI-to-DVI cable, only the Color and Tint (G/R) adjustment options
can be chosen.
Adjusts the brightness of individual pixels. Decreasing the brightness reduces power
consumption. This option is only available for LED TVs.
Cell Light
Adjusts the brightness of the panel. Decreasing the brightness reduces power consumption. This
option is only available for PDP TVs.
Contrast
Adjusts the screen contrast.
o
Adjusts the overall brightness.
Sharpens or dulls the edges of objects.
Color
Adjusts the overa II co Ior saturati on.
Tint (G/R)
Adjusts the ratio of green to red. Increase the green value to saturate the greens and the red
value to saturate the reds. _}_i/ i!
Applying the Cup'rent Pictu_e Quality Setting to Another _nput
Screen Menu> Picture > AppNy Picture Mode
You can apply the picture quality setting that you configured for the TV to all external devices
connected to the TV.
To apply the setting to all external devices connected to the TV, select ANI Sources. To only apply the
setting to the current input, select Current Source.