Storing Channels - Samsung series 6 650 User Manual

Channel Control
Storing Channels
[3 Antenna _ Air / Cable
Before your television can begin memorizing the available channels, you must specify
the type of signal source that is connected to the TV (i.e. an Air or a Cable system).
_3
_3
_3
You can also switch the air t cable by selecting Tools -_ 8witch to Cab!e (orAir)
Auto Program
• Air: Air antenna signal.
• Cable: Cable antenna signal.
• Auto: Air and Cable antenna signals
When selecting the Cable TV system: Selects the cable system. 8TD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in your particular area. At this point the signal
source has been selected.
After all the available channels are stored, it starts to remove scrambled channels.
The Auto program menu then reappears.
If you want to stop Auto Programming, press the ENTER_ button.
The Stop Auto Program? message will be displayed. Select Yes by pressing the 4 or i_ button, then press the ENTERIC,
button.
Clearing Scrambled Channel (Digital channelsonly)
The Clear Scrambled Channel function is used to filter out scrambled channels after Auto Program is completed.
This process may take up to 20~30 minutes.
To stop searching scrambled channels: Press the ENTERIC, button to select Stop.
Press the _1button to select Yes, then press the ENTER_ button.
This function is only available in Cable mode.
FineTune (Analogchannelsonly)
If the reception is clear, you do not have to fine tune the channel, as this is done
automatically during the search and store operation. If the signal is weak or distorted,
you may have to fine tune the channel manually.
Fine tuned channels that have been saved are marked with an asterisk * on the
right-hand side of the channel number in the channel banner.
If you do not store the fine-tuned channel in memory, adjustments are not saved.
To reset the fine tuning setting, press the T button to select Reset, then press the ENTER_ button.