Electrical Connections - Samsung DV456EWHDSU/AA User Manual

Gas and electric dryer
Hide thumbs Also See for DV456EWHDSU/AA:
Table of Contents

Advertisement

Available languages

Available languages

ELECTRICAL
CONNECTIONS
Before operating
or testing,
follow all grounding
instructions
in the Grounding
section.
An individual
branch (or separate) circuit serving only your dryer is recommended.
DO NOT USE AN
EXTENSION
CORD.
Gas models - U.S. and Canada
A 120 volt, 60 Hz AC approved
electrical
service,
with a 15-ampere
fuse or circuit
breaker is
required.
Electric models - U.S. only
Most U.S. dryers require a 120 / 240 volt, 60 Hz AC approved
electrical
service. Some require
120 / 208 volt, 60 Hz approved
electrical
service. The electric service requirements
can be found
on the data label located
behind the door. A 30-ampere
fuse or circuit breaker on both sides of
the line is required.
If a power cord is used, the cord should be plugged
into a 30-ampere
receptacle.
The power cord is NOT provided with U.S. electric model dryers.
IMPORTANT:
When local codes allow, the dryer electrical
supply may be connected
by means of a new power
supply cord kit, marked for use with a dryer, that is U.L listed and rated at a minimum
of120/240
volts, 30-ampere
with three No. 10 copper wire conductors
terminated
with closed loop
terminals,
open-end
spade lugs with turned
up ends, or with tinned leads.
Do not reuse a power supply cord from an old dryer. The power cord electric supply wiring
must be retained at the dryer cabinet
with a suitable
UL-listed
strain relief.
Grounding
through
the neutral conductor
is prohibited
for (1) new branch-circuit
installations,
(2) mobile
homes,
(3) recreational
vehicles,
and (4) areas where local codes prohibit
grounding
through the neutral conductor.
(Use 4-prong
plug for 4 wire receptacle,
NEMA
type 14-30R.)
Electric models - Canada Only
A 120 / 240 volt, 60 Hz AC approved
electrical
service fused through
a 30-ampere
fuse or
circuit
breaker on both sides of the line is required.
All Canadian
models are shipped
with the power cord attached.
The power cord should be
plugged
into a 30-ampere
receptacle.
I_lt
not permissible
to convert
a dryer
to
is
in Canada
208 volts.
installing
your dryer 15
DV400-03170A
EN HUDSON-PJT
vl.indd
Sec3:15
2012-01-20
N 1:58:28

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents