Troubleshooting - RCA P56925 User Manual

Color tv
Table of Contents

Advertisement

TROU B LESH OOTI NG
Troubles sometimes are caused by simple "faults"
that you can correct without the help of a service technician.
If you
experience
any difficulty
with your TV, check a few basic remedies before calling your service technician.
TV will not turn on
Check to make sure it is plugged
in.
Check the wall receptacle
(or extension
cord) to make sure it is "live" by plugging
in something else.
Maybe batteries
in remote control are "dead."
Maybe remote control
is not aimed at remote sensor.
The front
panel controls may be locked (disabled).
Use the remote control to unlock the front
panel controls by
selecting the Front Panel Lockout
in the Parental Controls menu and choosing Unlock.
Controls don't work
If using remote control,
make sure remote
is in TV mode by first pressing TV button.
The front panel MENU button
may be disabled. Use the remote control to turn off channel blocking.
Select
Channel Block in the Parental Controls menu and choose Off.
Try unplugging
set for two minutes and then plug it back in and turn it on again.
Problems
with Remote
Maybe something is between the remote and the remote sensor.
Maybe the remote is not aimed directly at the component (TV or VCR) you are trying to control.
Maybe remote is not in TV Mode.
Press the TV button so remote will control TV.
Maybe batteries in remote are weak, dead or installed incorrectly. Try replacing batteries. (Note, if you remove the
batteries, you may have reprogram the remote to control other components.)
Remove batteries and hold number 1 for at least 60 seconds to drain the microprocessor inside the remote. Release
number 1, replace the batteries, and (if necessary) reprogram the remote.
Remove all batteries for approximately
12 hours. Then replace batteries and (if necessary) reprogram the remote.
Turns off while
playing
Schedule off function
may have been activated.
Electronic protection
circuit may have been activated because of a power surge. Wait 30 seconds and then turn on
again.
If this happens frequently, the voltage in your house may be abnormally high or low.
TV Turns on unexpectedly
Schedule On may have been activated.
Blank
screen
Maybe the component connected to the input jacks is not turned on.
Try another channel.
Press RESET,in case the picture controls are set too low.
No sound, picture okay
Maybe sound is muted. Try pressing volume up button to restore sound.
Maybe speakers are turned off. Check the Audio Output and Speakers control panel in the Audio menu.
If using an S-VHS component,
remember to also connect the component's L and R AUDIO OUT jacks to the TV's L and R
INPUT jacks.
39

Advertisement

Table of Contents
loading

Table of Contents