RCA F19440TX1R9 User Manual page 19

.
Highlight the channel to which you have to tune your TV in order to see
cable programming, and press OK (a screen appears reminding you lo
connect your G-LINK cable to your TV and cable box).
Note: Cbarmel ()J i_ the mo_t common.
4. Highlight your brand of cal)le box, and press OK.
If your brand isn't listed, highlight Not LL_led and press OK.
5.
Make sure your cable box is on.
Tune tile cable box to channel 02 (use tile remote control that came with
your cable box, or press tile channel buttons on the cal)le box).
Press OK (tile GUIDE Plus+ system starts testing codes).
Important Note: When code testing is in p_'r_ress, don't touch your TK
VCR, cable box or a_ O, (f the remote control<fi)r these products.
.
Look at your cable box. If it is still on and changed to channel 09, tile lust
was successful. Highlight Yes, and press OK ($7t_P_:3: Cot_/i_urin/4jbr a VCR
appear._).
If your cal)le box didn't change to channel (}9 or turned itself off, you have
two choices: No and 7&vtthi._ code again.
7k, st this code again: If you think tile TV, the cable box, or any of lhe
remote controls might have been touched or bumped during the test,
highlight Te._tthis code c<,4ainand press OK (the GLIDE Plus+ system runs
the same set of codes).
No: If you don't think the test was interrupted, highlight No and press OK
(GUIDE I_lus+ system tesls tile next code).
Repeat tile previous instructions until the TV finds tile correct cable box
code. Follow the instructions on the screen.
Note: I]'the TV can 't find your cable box code, a trouble._hoot#<,4
chec/Wi._t appem:_. Car@d{y rc_'ieu each checklist andjbltow the
inst_vgctions on the scree_.
Chapter I 17