Connection: Tv + Vcr + Cable Box - GE 31GT750 User Manual

Connections & Setup
FromCabla Line
SIGNAL SPLITrER
VCR
VIOEO AU0r_
ANTENNA IN
CABLE BOX
trOUT
TV
Note: The GUIDE Plus+ system's One-Touch VCR Recontingfeature is not available with this
connection. If you want to use the One-Touch VCR Recording feature with your cable box, you must use
the TV and VCR connection on page 8. You can do so by routing the siKnal from your cable box into the
• antenna input on your VCR. Note that PIP won't work if you use this connection. This connection may
not be compatible with all cable services, especially if some or all cable channels are scrambled.
Connection: TV + VCR + Cable Box
1,
2*
Connect
Signal
Splitter to your VCR and TV
A. Use a Signal Splitter (not provided) to split the signal coming into the room. You can purchase
a Signal Splitter at your local electronics store or through the Accessory Order Form on
page 59.
B. Connect a coaxial cable to Signal Splitter and to the Input Jack on the VCR (sometimes labeled
ANTENNA IN).
C. Connect a coaxial cable to the Signal Splitter and to the CABLE IN Jack on the cable box.
Connect Cable Box to TV
Connect a coaxial cable to the TV OUT Jack on the cable box and to the CABLE/ANTENNA jack
on the TV.
3.
4,
Connect the 'IV to your VCR
A. Connect the audio cables (white and red) to the AUDIO IN jacks on the TV and to the Audio
Output Jacks on the VCR (sometimes labeled AUDIO OUT R and L).
B. Connect the video cable (yellow) to the VIDEO IN jack on the TV and to Video Output Jack
on the VCR (sometimes labeled VIDEO).
Connect G-LINK cable
A. If you haven't already done so, remove the Demo Pin from the G-LINK jack on the TV.
B. Connect the G-LINK cable to the G-LINK jack on the TV. Next step, place the wands of the
G-LINK cable to work with the VCR and cable box (instructions are on p. 13).
Go to page 13
12 Chapter 1